Although the ad from Rutland says the toolpost is for 10-15 inch lathes, it was obviously too small for my 14-inch as the previous owner had installed a riser plate underneath it. I would recommend that this equipment be used on lathes 12-inches and smaller similar to an Aloris AXA. One(1) 40-position toolpost w/tightening wrench. One(1) Mounting stud (3/4-inch diameter, 16 tpi, approximately 6-inches long) and flange approximate dimensions 2.25 x 2.5 x 5/8 with two(2) 0.25 x 0.375 x 2.5 inch rabbets. Note: Does not include nut. Three(3) 3/4-inch capacity turning and facing holders. ...